MikroTik

Hello,
I have a great problem when I use a pc with a dual core processor and a mikrotik relese 3.6 becouse the minipci prism 2511mp plus after few seconds doesn't make the
pppoe autentication can I have an help from you!!?? another problem is that the wep
encryption doesn't work well by some new tipe of client
best regards

disable Multi Core support in ROS
and also wait till ROS 3.7, it should release today

hi,
I have installed the ros 3.7 but the problem there is always.
if I disable the multi-cpu instead it correctly works the minipci prism!
how can I resolve?
regards
serenida

i don't understand you, if you disable multi-cpu , your card work or not ?????

hello,
yes when I disable multi-cpu the minipci prism works very well,
but how I can do for use the multi-cpu by this minipci prism, it is a bag
of ROS 3.7 ??
best regards
serenida

Hi, i don't sleep in all night! because yesterday upgrade all a network to 3.10 to do L2 Mesh Protocol, but in all RBs with a Prism Card this stop working, no wireless signal, traffic, connections, nothing? try downgrade to 3.9, reset-config of the card to default, but nothing, the card is not responding nothing in tx/rx

Downgraded to 3.2 all work again

Serious problem in lastest versions (i think post-3.7) and Senao 2511 or PRISM Card!

I was the first testing this? fuc......

Serious problem in lastest versions (i think post-3.7) and Senao 2511 or PRISM Card!

I was the first testing this? fuc......

You're not alone! All of our network consists of Senao 2511 cards for Access Points (We use CM9 only for backbone). Performance is terrible... Maximum download speed around 160-170K. I really hope Mikrotik comes up with a fix soon. We can't really afford to change all of our Senao just because ROS3 doesn't support it!

Downgraded to 3.2 all work again

Maybe this is the explanation:

*) updated drivers;