dcma-82 isue on RB 411A
Posted: Wed Aug 13, 2008 4:27 pm
hey guys,
I've had many trobel in several RB411A board with dcma-82 cards. if i enable the cards from default congiguration the board sudenly switch off. if i change the configuration before enebling it such as change the mode itu 2,4B and AP bridge then enabling them, it runs smoothly.
when i change it again into 5ghz & station mode ... the board switch off again.
is there any way to get around this isue ???
any advice ?
thanks
ps : it's never happend before and only start to happend from the last two shipment...
I've had many trobel in several RB411A board with dcma-82 cards. if i enable the cards from default congiguration the board sudenly switch off. if i change the configuration before enebling it such as change the mode itu 2,4B and AP bridge then enabling them, it runs smoothly.
when i change it again into 5ghz & station mode ... the board switch off again.
is there any way to get around this isue ???
any advice ?
thanks
ps : it's never happend before and only start to happend from the last two shipment...