Page 1 of 1
any one help me ?
Posted: Mon Sep 22, 2008 4:50 am
by mazen
wt is the Volt and ampire to rb433 and rb433ah to work good ?
notice without poe !!
thnx
Re: any one help me ?
Posted: Mon Sep 22, 2008 5:00 am
by roc-noc.com
The 18POW supply sold by Mikrotik is 24volts DC .8 amp (19 watts). This works fine with both RouterBoards and 1 or 2 low power radio cards (r52 or r52H) or 1 higher power card (like an xr2).
If you are running more radio cards then it is wise to use the higher power supply like the 24HPOW which is 24 volts at 1.6 amps (38 watts).
Tom
Re: any one help me ?
Posted: Sat Sep 27, 2008 3:24 am
by mazen
thnx mr. Tom
wt about the power ( volt and amp ) with poe !
in 433 , 433ah
r52 , xr2 and many xr2
thnx
Re: any one help me ?
Posted: Sun Sep 28, 2008 1:59 am
by roc-noc.com
I would use the 24HPOW 24 volt 38 watt supply and the RB/P54 passive POE injector when using more than one XR2 card with a RB433 or RB433AH.
I am not sure why you are saying "many" XR2. You can only fit two in the triple shot connector used on the RB4xx series RouterBoards.
Tom
Re: any one help me ?
Posted: Mon Sep 29, 2008 3:59 am
by mazen
thnx mr. Tom
i understood from you :
when i use poe , use 24HPOW 24 volt 38 watt supply in any case
right ?
Re: any one help me ?
Posted: Tue Sep 30, 2008 7:43 pm
by mazen
plz any ans !
Re: any one help me ?
Posted: Wed Oct 01, 2008 7:04 pm
by mazen
helppppppppppppppppp
Re: any one help me ?
Posted: Wed Oct 01, 2008 7:14 pm
by netrat
Your question has already been answered. The case does not matter.