Configuring a Wireless Bridge connection
Posted: Wed Oct 22, 2008 7:03 pm
I've finally got my Routerboard 433 working properly.
The manual doesn't describe configuring a bridged connection, so I'm here.
What I have:
I have one Wireless AP-Bridge with an SSID of "office" this access point is connected to the router where the DSL connection resides.
I have a second Wireless Client-Bridge set up with an SSID of "home" this is where I want to bridge the wireless to.
My Routerboard has two Atheros 2.4ghz radios.
What I need is to know is what settings to I need to use to bridge these two connections.
I do not want NAT or anything else, I would like all traffic to pass-through (just like a switch would handle the traffic).
All your help is greatly appreciated.
The manual doesn't describe configuring a bridged connection, so I'm here.
What I have:
I have one Wireless AP-Bridge with an SSID of "office" this access point is connected to the router where the DSL connection resides.
I have a second Wireless Client-Bridge set up with an SSID of "home" this is where I want to bridge the wireless to.
My Routerboard has two Atheros 2.4ghz radios.
What I need is to know is what settings to I need to use to bridge these two connections.
I do not want NAT or anything else, I would like all traffic to pass-through (just like a switch would handle the traffic).
All your help is greatly appreciated.