Need to configure load balancing with Ratio balance.
Posted: Tue May 24, 2005 3:41 pm
Hi i have a network setup as per diagram below
I need to set the traffic over the serial line until full then send data over the wireless/ether link.
Data leave the mikrotik and arrives at the cisco. it leaves via ether1 and 3. The serial is 1Mb the ether is 10Mb (limited by cisco ether port)
What is the best way to implement this. ???
I may also need to allow the lines to be ratio EG 80:40 serial:ether
or 80:40 Ether/serial.
I also want redundant links - perhaps static routes to back up with > Ad distance?
Please let me know what you think.
Regards
Malcolm
I need to set the traffic over the serial line until full then send data over the wireless/ether link.
Data leave the mikrotik and arrives at the cisco. it leaves via ether1 and 3. The serial is 1Mb the ether is 10Mb (limited by cisco ether port)
What is the best way to implement this. ???
I may also need to allow the lines to be ratio EG 80:40 serial:ether
or 80:40 Ether/serial.
I also want redundant links - perhaps static routes to back up with > Ad distance?
Please let me know what you think.
Regards
Malcolm