Hello guys has anyone tried the routing module for BGP on RouterOS v3.25. My systems are due for update next week has anyone tried it with multible peers ????

I was forced to upgrade my bgp routers to 3.25 due to some bug with a newer version of Cisco routers, that was triggered after one of my upstreams upgraded their routers. So far, it seems stable. I haven't stress-tested it, but my routers are stable, and that's what counts for me

yes, i have some rb/1000 with ROS 3.25 and multiple peers. it work. some small problem but it's ok, 3.24 is very bad.

How many peers do you have active. I have 5 and they cause a lot of problems when the other end uses cisco bgp v3.

Sotiris

On a RB/1000 i have 3 IPv4 and 1 IPv6 peer with 3 ipv4 full table and 1 ipv6 full table, without trouble (only some lag when i change some filter or similar..)

Only some lag?
Previously, on 3.24, my peerings would go down if I changed any filters. Is this not the case with 3.25? I've been too paranoid to test it out myself

There are Cisco BGP compatibility issues fixed in this release.

I've the problem with 3.16 (routing-test and normal routing) peering with cisco.
When the peering cisco resets the bgp session to an other peering this cisco
forgets our announcement. So I have to do a manual "Resend" on 3.16.
This fixes the problem immediately. As this ciscos have no problems with other
ciscos this seem to be a ROS-Cisco issue.
Is this fixed in 3.25?

I'm using 2 RB1000 to different ciscos (redundant peering). Each of them has
this problem. Peerings are directly connected by Ethernet.

Stefan

I believe there is a problem with Junipers as well not ciscos. Plus my peers keep crashing once a week. And the errors I get in the logs are not informative at all.
Next time I'll send an spout to support.

Sotiris