Page 1 of 1
Connecting ether2 on 133c board and ether2 0n 532 board
Posted: Sat Aug 15, 2009 11:47 am
by daitea
i want to connect two boards together on a tower by using their ether2 ports and a straight cable.
it is connected alright and i can see both in the neigbours and i can ping the mac adresses but can not reach them by the ip addresses
please help
Re: Connecting ether2 on 133c board and ether2 0n 532 board
Posted: Mon Aug 17, 2009 2:13 pm
by sergejs
Check the IP address configuration and ip route configuration.
There should not be nothing wrong on the RouterBOARDs.
Re: Connecting ether2 on 133c board and ether2 0n 532 board
Posted: Tue Aug 18, 2009 3:53 am
by daitea
should the ip be in the same block with the same subnet mask?
like if board a has 10.10.10.1 255.255.255.0 and board b 10.10.10.2 255.255.255.0 OR a have 10.10.10.1 255.255.255.0 and b 10.0.1.2 255.255.255.0?
then in the route i have problem making traffic pass through each other. it becomes very slow
Re: Connecting ether2 on 133c board and ether2 0n 532 board
Posted: Thu Aug 20, 2009 10:03 am
by sergejs
When the boards are on the same Ethernet network, use the same subnet for them.