MikroTik

I have 2 MTs both with a 3com ethernet interface and a routerboard 44.

I made a bonding on the interfaces of the routerboard 44 on MT1 and MT2 such as shown in the example of the reference.
Ping doesn't work.

When I disable bonding on both machines and bind the ip address of bonding1 to ether1 I can ping each other.

Can anybody help me.

Thanks.

I don't know why it doesn't work properly, but have you tried configuring an EoIP tunnel over each link, and then bonding the EoIP tunnels?

Hitek

No. But I just will try it.

You have to bond EoIP tunnels!
I got it to work at my house, so I took it to a PC shop and bonded their two dsl lines back to the Co-Lo and it worked. But the over head was 35% or more.
I never could get any of the fellover to work.

The next day I tried to set it back up at my house and I couldent get it to work again.

I stopped dicking with it since Joe got the JoeBonder working like a dream machine from the future.

I tried to made a eoip tunnel interface on both MTs but I can't ping the other MT

Finaly I got my eoip tunnel running (I didn't bridge the physical interface to the tunnel interface).

Made four tunnel interfaces on each MT and can ping the remote addresses. Everything works fine. But when I try to make a bonding interface I don't get a connection on that interface.

Where can i hear more about the JoeBonder! I would love to make him famous on my network, if he has a working solution. Please forward any info you willing to release! thanks

Matt Bochsler
PineValley Networks

You have to bond EoIP tunnels!
I got it to work at my house, so I took it to a PC shop and bonded their two dsl lines back to the Co-Lo and it worked. But the over head was 35% or more.
I never could get any of the fellover to work.

The next day I tried to set it back up at my house and I couldent get it to work again.

I stopped dicking with it since Joe got the JoeBonder working like a dream machine from the future.