Dude Monitoring a RB1000 with +500.000 routes
Posted: Tue Sep 22, 2009 9:43 pm
Hi all,
I'm using Dude to monitor my entire network and its doing a very nice job! but, when I try
to monitor one RB1000 receiving two BGP full routing session the rb cpu goes to 100%
and dont come back to normal until I disable dude snmp monitor.
I know its happens because of the number of routes running on that system, so my question is:
there are any way to monitor RB1000 intefaces and cpu usage without getting all routing table?
I dont need any walk thru routing table or arp table, just need cpu and traffic monitor.
Thanks,
Jorge
I'm using Dude to monitor my entire network and its doing a very nice job! but, when I try
to monitor one RB1000 receiving two BGP full routing session the rb cpu goes to 100%
and dont come back to normal until I disable dude snmp monitor.
I know its happens because of the number of routes running on that system, so my question is:
there are any way to monitor RB1000 intefaces and cpu usage without getting all routing table?
I dont need any walk thru routing table or arp table, just need cpu and traffic monitor.
Thanks,
Jorge