Page 1 of 1

little upgrade mistake

Posted: Fri Jun 24, 2005 1:55 pm
by amtisrac
Hello
I found a little mistake. The old release use same port to winbox. When upgrade it I lost the communication, because the firewall block the new winbox port. Please put a new rule to enable the new port, when it is changed!
(The router is far away, in a high tower :) so I must walking a little)

Posted: Fri Jun 24, 2005 3:20 pm
by HarvSki
Can you not SSH into it? then open the firewall

Posted: Fri Jun 24, 2005 4:49 pm
by taloot
try to telnet it it if it got connected
go to ip firewall filter
then do a print
and remove the rule that block all traffic

Posted: Sun Jun 26, 2005 1:56 pm
by amtisrac
I blocked any other incoming port included ssh telnet etc (because I'm very paranoid? ;) )
/the problem solved from local console - give a new rule with the new port/