I have working Queues on 3.20 x86
when i'm updated system to 3.30 x86 my working queues don't work, now i have 2 problem , i have deleted all queues & all firewall/manage/nat rules.
I have high pings to my GW and other hosts!!! and packet loose 5-10%
Tx/Rx - 200Mbit/200Mbit
pps ~ 35k-40k
system load 35-40%
where is problem?

Simple queues do not work with Xen package. Do you have it installed?

no i have not installed this package,
problem was solved with packet loose! (was in PCI Intel/PRO 1G network cards) Intel PCI-x dual port is working good now
queues not work propertly

please post more details (config, etc.)

Looks like there is some bug or change in 3.30 queues.
After executing command packet mark attribute disappears. instead works ok.
Maybe you have the same problem with simple queues - packet marks are gone?

Yes me too.. V 3.30 on RB 750 and RB 433
the traffic is not counted and not appear in simple queue when i set to 'unlimited' limit.
Fix please..

Yes me too.. V 3.30 on RB 750 and RB 433
the traffic is not counted and not appear in simple queue when i set to 'unlimited' limit.
Fix please..

'Unlimited' is a default value. If all other queue properties are also default values the queue will not take effect since it wouldn't do anything, as per the official documentation.
Post such a queue that isn't counting packets if you think that doesn't apply to your case.

zulhanif, simply change at least something: for example, set type to 'default' instead of 'default-small'

zulhanif, simply change at least something: for example, set type to 'default' instead of 'default-small'

Oh..thanks..it work now..thanks Chupaka