AP: RB411A, SR2, Nstreme (best fit 3200) overall CCQ 95+, 90deg sector,
Clients RB411, R52H.
All software is 3.30 with wireless test on all CPE's and AP.
AP RF modulation is default. Clients are limited to 24-36mbps depending on ccq qaulity
29 clients all with -70 or better signal, 80+ CCQ, ap overall ccq is around 95+
Clients limited to 1.3mb down and 300k up, limited by Radius or access list (tested with both)
If any single client is down loading their max 1.3mbps then the latencies goes up to 1-2 seconds and no other through put is available to any other client. Ap's total traffic is maxed at about 1.5mbps
If clients are not maxed out (down loading at 1 or 1.2 mbps) latency is typically under 30ms until the AP hits about 5-6mbps when the latency jumps to 200ms +. AP appears to max out at 6-7mps.
We have tried all possible combination to fine tune the AP and clients. Same Results with out Nstreme. we have other similarly loaded aps that function fine(ap's are all 3.3 with test, clients are 3.10 and up). I have another behaving the same way.
Any one else have/had the same issue any ideas as to a fix? I'll likely send in