MikroTik

Posted: **Sat Feb 13, 2010 1:18 am**

How do you insert the 'date&time' of the down in the label?

One can see the status change as it happens showing the probe condition but...

How does one see the down "date&time" event in the label on the map live?

I know you can insert Date & Time, but that's the current Date & Time of the reveal.

Example... [device_performance()][Device.ServicesDown] this is as close as it gets now...
Would be nice if their was something like this...
[device_performance()][Device.ServicesDown][Device.ServicesDownTime] or [Device.ServicesDownDateTime] in the label on the live map.

This needs to be done without using... SNMP!!!

Thanks & Cheers!!!

This "The Dude" software is awesome!!!

CHEERS!!!

Posted: **Sun Feb 14, 2010 10:38 pm**

[Device.ServicesLastDownTime]

Posted: **Sun Feb 14, 2010 11:19 pm**

slech...

That is not a valid query in Version #3.5... [Device.ServicesLastDownTime]

I could not find it in the "Appearance" selection of the Label of the Device!!!

;^(

Posted: **Fri Jun 18, 2010 7:01 pm**

This would be a good idea, How about implementing it in the next version

MikroTik

How do you insert the date&time of the "down" on the label?

How do you insert the date&time of the "down" on the label?

Re: How do you insert the date&time of the "down" on the label?

Re: How do you insert the date&time of the "down" on the label?

Re: How do you insert the date&time of the "down" on the lab