Hi

I'm trying to setup mpls. I'm following this example
http://wiki.mikrotik.com/wiki/MPLS_Lab_Setup

But it seems not to work.
I have 3 routers connected together just like the core routers in example. The addresses are assigned and OSPF routing works just fine there is a ip connectivity between all hosts etc.

But mpls seems not to work I did enable mpls/ldp, created the lobridge interface and added interfaces to ldp discovery.
There are ldp neigbours visible but there are no addresses associated with them and no local or remote label-bindings.
Traceroute with src of the lobridge interface can't reach destination so I assume that MPLS does not work.

Should I enable something else so the labels get assigned to routes and etc.?

I'm using RO 4.11 and RO 5.0

I assume there is some simple thing that I'm forgeting about some basic step needed to make it work.
Maybe there is some MPLS guru that will enlighten me

Check if OSPF is distributing connected routes.

Yes it does all routers are aware of all existing networks etc.

<<<<edit>>>>

It seems that "mishaM" advice from that post http://forum.mikrotik.com/viewtopic.php?f=14&t=40219, solved the problem.
At least on 2 test test routers, after removing transport addressthey get local and remote bindings assigned and VPLS tunel works.

Later I'll check if it works in bigger network.

I have another question although i suppose it should be asked in newbie area
"How do I make the router to label switch packets instead of routing them?"