Page 1 of 1
RB 411 help!!!
Posted: Sun Oct 03, 2010 11:58 am
by nicmo
Hi to all, I have a problem with my RB411 board look like i disable ether1 with winbox not its not seeing the RB, how can i reset it to default?
Nicmo
Re: RB 411 help!!!
Posted: Mon Oct 04, 2010 12:38 pm
by Ibersystems
You can enter the board via COM port and enable ether1. It's not necessary to reset the board.
Re: RB 411 help!!!
Posted: Tue Oct 05, 2010 6:20 am
by nicmo
Thanks for the reply, I tried to connect via com port but the screen auto scrolls. Any suggestions?
Nicmo
Re: RB 411 help!!!
Posted: Tue Oct 05, 2010 7:06 am
by fewi
Did you select a baud rate of 115200? Access through the serial port should always work.
Re: RB 411 help!!!
Posted: Tue Oct 05, 2010 7:28 am
by nicmo
Yes I did.
Re: RB 411 help!!!
Posted: Tue Oct 05, 2010 12:46 pm
by Ibersystems
115200 and press enter in Terminal... and It should work : /
you can enter terminal and connect the board.. then you'll see letters, if you see symbols, try another baud rate.
Re: RB 411 help!!!
Posted: Thu Oct 21, 2010 4:54 am
by nicmo
Maybe the cable was too long so i build a shorter one and it works great.
Thanks for all the suggestions.