MikroTik

Hi, I am doing a ground test with RB411ar as AP and RB411 as station mode, I can ping my internet gateway from RB411 wireless in winbox but not from PC. I got DHCP IP for the pc from the internet router through ether1 on RB411 bridge to the AP.

Have you configured masquarade ?

If yes and its still not working copy and paste config here,

How to configure masquarade and how to copy the configuration?

Dear Sir,

For masquerading packet from your local network , you can setup a new rules from IP firewall NAT . TIA

Best Regards,

Ojie Nugraha

In winbox go to IP>Firewall>NAT>Action>Masquerade ?
Should I do this on both AP and Station?


Nicmo

Hi I found out that when i was pinging through winbox it was on Any interface. The only interface i can ping my internet gateway from is the bridge none of the others worked. Any suggestions??

Thanks in advance.
Nicmo