MikroTik

I am fairly new to the Dude and was if it is possible and how to do the following? I have some devices which I can read the association list Mac address, RSSI, Tx Rate, Rx Rate etc via SNMP. I would like to be able to pull and display that information in the dude. The only way I can think to do this would be through the use of the label of the device but this doesn't seem like it would work very well. Is there another way to approach this?

Eric

I would display the Mac address in the device label and then use a probe to graph the RSSI and place a link between the device and switch to display and graph the Tx and Rx rates.