Hello, I have recently installed a wireless backhaul using 2 RB/411AH with Ubiquiti XR5's.
I followed the instructions on this page to a t:
http://wiki.mikrotik.com/wiki/Transpare ... o_Networks

They could pull 14 megs per second on the bench.
Once installed I was getting about 12 megs per second doing a scp.

I was able to use them fine for the hop they were intended, today a different link went down and i rerouted its traffic now over this mikrotik link.
It seems with more connections it only can move at 8-9 megs per second.

This is my first mikrotik link. Are these numbers what I should expect, or is there a better way of configuring these for higher performance?

Much Thanks,
Kevin

what are the values of signal strenght, ccq and distance? do you have clear LOS?

what are the values of signal strenght, ccq and distance? do you have clear LOS?

My signal strength is -70 at on end and -71 on the other.
My CCQ jumps around between 45% and 75% on both sides
Its a 12 Mile link with a clear LOS with nothing in its fresnel zone.
I have disabled all speeds under 24Megs.

I would be excited to see them run faster on the bench as well

Thanks much,
Kevin

i have MT link with rb 433ah at 2 miles running 108Mbps 5Ghz with Nstream on horz. Link does about 35 down and 35 up. Also my Antenna is a dual polarity so there is a extra wireless card on both ends so later i can bump it up more.

I would try and enable Nstream. It may double the speed you are getting.

Thanks for the input nny. I was under the impression you needed dual polarity for Nstream.
I have a new link showing up tomorrow and will give it a shot.