MikroTik

Hello
i have the mikrotik board work in wds looking to connect 4 devices eoc-2610 with WDS Bridge...
but in this 4 devices connected 2 only

i don't know whay this happen !!!
you can see the frimeware in this it in one device same anther eoc-2610 connected to mikrotik .


in 4 eoc-2610 have same settings ... but the 2 the devices has been conncted to mikrotik can't see the signal but it's connected !!!!

--
is that mean i need new frimware to my devices to it be conncted ok with mikrotik ?
------
the frimware EOC-2610-engenius-1.0.37 with fix this problem if i'm use the super channel in mikrotik and eoc-2610 if the frimeware EOC-2610-engenius-1.0.37 support super channel ?
or i need anther setting in my board ?
like this pic ?


or i need anther seeting in my devices ?
plz i'm wating your answer
thank you

regular wireless devices, like the engenius, don't know anything about superchannel. superchannel allows you to set "NON STANDARD" frequency. As the name suggests, "NON STANDARD" could possibly not work in devices that operate only in STANDARD frequencies.

regular wireless devices, like the engenius, don't know anything about superchannel. superchannel allows you to set "NON STANDARD" frequency. As the name suggests, "NON STANDARD" could possibly not work in devices that operate only in STANDARD frequencies.

thank you