Page 1 of 1
[SOLVED] Radius Timeout problem after 5.2 upgrade
Posted: Mon May 16, 2011 3:28 pm
by felipesilveira
Hello all, we have some pppoe concentrators using mikrotik (we use freeradius to authenticate users), them after I upgraded to 5.2 my username/password errors was not described as "authentication failed" anymore, the 5.2 version is describing as "authentication failed - radius timeout" the username/password errors, could someone help me if this situation is right? And if it is a issue them it will be fix on 5.3 version?
I think that is not a "radius timeout" this is a error only with the username and password, I'm right?
Thanks in advance
Re: Radius Timeout problem after 5.2 upgrade
Posted: Mon May 16, 2011 3:31 pm
by SurferTim
The timeout is due to a delay in the response of a bad request. If the RADIUS request is accepted, the response is sent immediately. If it fails, the server waits about 2 seconds before responding with the reject message. Prior to V5.x that was apparently not a problem.
Try this:
/radius
print detail
set 0 timeout=3s
EDIT: My bad. It is just "timeout", not "radius-timeout".
Re: Radius Timeout problem after 5.2 upgrade
Posted: Mon May 16, 2011 3:47 pm
by felipesilveira
Perfect you are right! I set now to 3 sec and the problem was solved.
Please could someone close this topic?
Re: Radius Timeout problem after 5.2 upgrade
Posted: Mon May 16, 2011 3:50 pm
by SurferTim
Perfect you are right! I set now to 3 sec and the problem was solved.
Please could someone close this topic?
Add "(Solved)" to the end of the subject in your first post. Login and click the "edit" button on your first post.
Re: [SOLVED] Radius Timeout problem after 5.2 upgrade
Posted: Mon Oct 17, 2022 1:53 am
by Shahid