MikroTik

On a Intel D525MWV mini-itx motherboard with 5.x or 4.17 ( just haven't tested more ) when you ask for a reboot the system hangs after announcing "rebooting" Anyone have any ideas about this? I'm hunting around for my serial cable to see what is on the console

Thanks!

try to install routerboard package, maybe it helps

Already in there...

Dear, I have a motherboard Intel Atom 525, Atom D525 processor 1.8 GHz with 4 cores, mikrotik install it without problem, but the problem starts when you get a rb44 (10/100) and it takes me only 1 ethernet port, the same rb44 install it on another PC and works with the 4-port, but when I install Windows 7 on Atom motherboard, the 4 ports are working properly, I hope someone has the solution because I really need the large capacity of the microprocessor to router .

If you tell your 525 w/Mikrotik to reboot does it fully reboot without hanging?

On a Intel D525MWV mini-itx motherboard with 5.x or 4.17 ( just haven't tested more ) when you ask for a reboot the system hangs after announcing "rebooting" Anyone have any ideas about this? I'm hunting around for my serial cable to see what is on the console

Thanks!

Obviously, see where it hangs with the serial cable connected.

I am not sure if this applies, but try a different brand of RAM. I have seen this happen on RB1000 and RB1100 RouterBoards when running certain brands of SDRAM. The "bad" RAM would pass all RAM tests but would hang on reboot. My solution was to find a brand that rebooted properly.

Good luck,

Tom

FWIW I have been running ROS 5.x versions on both Atom D510 boards and Atom D525 boards without any reboot problems.

D'oh, there isn't anything on the Serial port, this is an Intel MB... No help there.. But the solution was the latest BIOS from Intel..

Once I loaded that on up, all was good...


Thanks for the suggestions...


Karma?

BTW, I am a good Roc-Noc customer, thanks for being there!

updated the bios to my I worked, now restarts correctly