MikroTik

Why no one said nothing about the RB711UA-2HnD
Is someone out there has try it?

got 1 working
looks good

I have one up and running. Probably the most versatile Routerboard I have at the moment.
Works GREAT... And just demonstrating it has already influenced others to order one.
I really like the built in USB port as I have been doing some really nice failover scenarios with a Sprint 598U CDMA 3G stick.
IMHO, for the money, it's the best product they have produced so far!!

-tp

Can i please have installations pictures,
how you connect to your antennas?
the Chain you use
and the enclosure

This Are some picts

This Are some picts

Can i Know the Config , I am Newbee , I am getting very poor results

This Are some picts

Can i Know the Config , I am Newbee , I am getting very poor results

Hi
you mean that your Using the RB711UA-2HnD and getting very poor results ?

Hi,
pls someone reply to this post.
I am having 12pcs of 711UA-2HnD in hand and all in office only, not able to sell single. Because its working very poor in single polarization antenna(omni/sector).
I connected 711UA-2Hnd with sector antenna and configured as AP with chain0 enabled and antenna conencted in chain0. when i connect my client device with AP signal it shows the following error 'CONNECT FAILED' even signal strength is very good and no security in the AP side.

but when i use with MIMO sector its working well.
If any configuration to do, pls let me know.
Thanks in advance
bala

Hi,
pls someone reply to this post.
I am having 12pcs of 711UA-2HnD in hand and all in office only, not able to sell single. Because its working very poor in single polarization antenna(omni/sector).
I connected 711UA-2Hnd with sector antenna and configured as AP with chain0 enabled and antenna conencted in chain0. when i connect my client device with AP signal it shows the following error 'CONNECT FAILED' even signal strength is very good and no security in the AP side.

but when i use with MIMO sector its working well.
If any configuration to do, pls let me know.
Thanks in advance
bala

Hi

In winbox,
New Terminal

Reset: system reset-configuration.

Wireless
interface (Name)
apply
mode: AP Bridge (If you are not manage your client In the "711UA-2HnD" )

Terminal:
inteface bridge
inteface bridge add name=(Name)
print
port
add interface=wifi bridge=(Name)
add interface=ether1 bridge=(Name)

interface bridge port print

Hi there!
can someone please give me the configuration to this to work as Hotspot
it is just for about 10 users
thz