Bridge Traffic not showing in 2.9.10
Posted: Thu Jan 05, 2006 6:27 pm
I recently upgraded a couple of 532s to 2.9.10 and am seeing some strange things. I had a bridge which contained a couple of wirless interfaces operating in AP Bridge mode. When I upgraded, the bridge was still there but I had to add all the interfaces again. This was fine and I got it all working, but now my bridge does not show any traffic comming through it. I have a hotspot set up on the bridge, and it seems to be working fine, but again, when looking at the interfaces, the bridge shows no traffic passing but the individual interfaces do. However if I run torch on the bridge, everything seems to be comming through it. This isn't a huge deal as it appears the bridge is working, but all my snmp monitoring shows no traffic on the bridge as well. I'd like to be able to monitor the bridge traffic. I tried to disable the bridge and re-enable it. At this point it started showing traffic passing coming through it, but then the hotspot interface went invalid and wouldn't come back until I rebooted the router...but then the bridge was not showing the traffic coming through it anymore...so I'm back to where I started. Is MT aware of this?
Cameron
Cameron