Hi,

Can any one advice me the robust link advice steps one by one. I like to setup point to point link with station WDS as a client side and at central side i have RB433AH

can any one share step by step method for cofiguring the point to point link.


Regards

Nishit

for point to point i use bridge on one side, protocol unknow, only n, for 5ghz i recomend the f50npro mini-pci card, super channel for choice the best channel, on data rate a use advance data rate, on nstreme activated an framer-police best fit, on ht activate the four check for dual polarity, your best gain conectivity must be from -50 to -68 out of this range you have not good result on the other side i use the same configuration but on staion bridge.