i need some basic help please.
I'm fighting with the two switch chips on the RB493G
ether10 - WAN
ether11 is master port for ether12-ether14
ehter15 is master port for ether16-ether17
Then i have setup bridge1
ether11 and wlan1 are designated ports on bridge1
Then i have setup a dhcp server to run on bridge1 with an adress pool.
All of this works. I can connect clients on ether11-ether14 as well as on the wlan. I can obtain ip-adresses and also everything else works.
But now i don't get any further. How to proceed with ether14-ether17? I cannot get it running.
I tried to create a bridge two and then setup the ports, but they always end up as invalid (role: disabled port)
Maybe someone can enlighten me?
