Page 1 of 1
ROS 5.22 WDS mode dynamic-mesh not running
Posted: Sun Dec 23, 2012 12:39 pm
by tkgit
for my expanding network,i research WDS dynamic mesh mode, why when i use ROS 5.22 my WDS network can't connect? it's a bug?
when i use ROS 5.14 it's work correctly
Re: ROS 5.22 WDS mode dynamic-mesh not running
Posted: Tue Dec 25, 2012 2:49 am
by NicholasMag
I run my RB411GL's and Omnitik's on ROS 5.22 using dynamic-mesh and everything works great.
Whats your configuration?
Re: ROS 5.22 WDS mode dynamic-mesh not running
Posted: Wed Dec 26, 2012 4:18 am
by tkgit
this is my config
Re: ROS 5.22 WDS mode dynamic-mesh not running
Posted: Thu Jan 17, 2013 11:48 pm
by elmer
Today i tried connect two OmniTik`s with MESH, and i am not satisfied...
550 meters (with google maps), dual chain A/N 20/40mhz and only !ONE! Mbit works.
Signal on both of them is about -72 - this is normal?
Devices on this same height, clean terrain / visibility 100%
Re: ROS 5.22 WDS mode dynamic-mesh not running
Posted: Sat Jan 19, 2013 12:30 pm
by tkgit
Today i tried connect two OmniTik`s with MESH, and i am not satisfied...
550 meters (with google maps), dual chain A/N 20/40mhz and only !ONE! Mbit works.
Signal on both of them is about -72 - this is normal?
Devices on this same height, clean terrain / visibility 100%
if only 2 node,i think it's not mesh,just PtP CMIIW,
my network diagram like this :
OSPF-Bridge.jpg
this is result btest from a node in my network
532A-btest.jpg
but it run in dynamic WDS-mode, not dynamic-mesh
Re: ROS 5.22 WDS mode dynamic-mesh not running
Posted: Mon Jan 21, 2013 2:47 pm
by elmer
I want to connect more of this devices, test was on two only...