MikroTik

Hi,

I don't know this is possible, but if it is it would be great:

I've 2 address list items defined in my IPV4 firewall

- Server 1 - 192.168.1.1
- Server 2 - 192.168.1.2

For both servers I would like to allow all traffic on port 80, now I create 2 identical rules to allow traffic on port 80 to this 2 address lists, the only difference between the 2 rules is the address list item.

Now my question: Is there no possibility to create a group let's say 'Servers' with as members of this group server1 and server2 ? So thas I can use that group in my policy instead of the address list items itself.

If it is possible how do I achieve my goal ?

With regards,

Hi,

after you create address list you can configure only one rule for those servers

So you need to name all address list items the same to create a group?

Strange way but OK

look at it in this way - you add address list and choose group i belongs to. You are not naming the address. So for the first address in list you have to enter the name, since you do not have desired group yet, but for all the following addresses in the list you just check that this address is part of certain group

It makes sense to me. Just like radgroupreply table with FreeRadius....