I need to use mikrotik web proxy "just for logging get url addresses" with a load balance.
If i use ppc load balance proxy uses only one wan connection.
Is there any way that, i can use mikrotik proxy with some kind of load balancing on same device 493G or 1100AH.

Thank you for your help.

probably you mean pcc, not ppc...
which classifier are you using?

and why not just equal cost multipath ?

yes pcc sorry, i can use ecmp of course if it works i am open to suggestions. Can't find any thing about using internet proxy with load balance
I just need some kind of load balance which works with mikrotiks built in proxy opened

I suggest starting from

http://wiki.mikrotik.com/wiki/Load_Balancing

... and for my little experience i think ecmp is the simpler way to have load balancing.

Web proxy is on a complete different level than load balancing, you must look at the two thing separtely: each load balancing can go with web proxy, just you can't expect to classify trafic based on src address.

Yes.. I know, i need web proxy because of two things.

1-Client wants to block all internet access allow users to connect through only allowed url's 'blocking content works with firewall but allowing does not work'.
2-He needs a web proxy output for logging web sites

and he wants to use load balancing.

Any ideas how can we achive this configuration?

I have already used my Mikrotik below setup for PCC Load Balancing with Web Proxy.
I hope it will be work for all.
I am working on MikriTik RouterOS 5.23 (X86)
My Mikrotik has 3 interface.

/ ip address
add address=192.168.0.1/24 network=192.168.0.0 broadcast=192.168.0.255 interface=Local
add address=192.168.2.1/24 network=192.168.2.0 broadcast=192.168.2.255 interface=wan1
add address=192.168.4.1/24 network=192.168.4.0 broadcast=192.168.4.255 interface=wan2

/ip route
add dst-address=0.0.0.0/0 gateway=192.168.2.1 routing-mark=to_wan1 check-gateway=ping
add dst-address=0.0.0.0/0 gateway=192.168.4.1 routing-mark=to_wan2 check-gateway=ping
add dst-address=0.0.0.0/0 gateway=192.168.2.1 distance=1 check-gateway=ping
add dst-address=0.0.0.0/0 gateway=192.168.4.1 distance=2 check-gateway=ping

/ip firewall nat
add action=redirect chain=dstnat disabled=no dst-port=80 in-interface=Local protocol=tcp to-ports=3128
add action=masquerade chain=srcnat disabled=no out-interface=wan1
add action=masquerade chain=srcnat disabled=no out-interface=wan2

/ip firewall mangle
add action=mark-packet chain=output comment="Cache Hits/Dotnet" disabled=no dscp=4 new-packet-mark=cache-hits passthrough=no
add action=mark-connection chain=input disabled=no in-interface=wan1 new-connection-mark=wan1_conn passthrough=yes
add action=mark-connection chain=input disabled=no in-interface= wan2 new-connection-mark= wan2_conn passthrough=yes
add action=mark-connection chain=output disabled=no dst-port=80 new-connection-mark=wan1_conn passthrough=yes per-connection-classifier=both-addresses:2/0 protocol=tcp
add action=mark-connection chain=output disabled=no dst-port=80 new-connection-mark=wan2_conn passthrough=yes per-connection-classifier=both-addresses:2/1 protocol=tcp
add action=mark-connection chain=prerouting disabled=no dst-address-type=!local dst-port=!80 in-interface=Local new-connection-mark= wan1_conn passthrough=yes per-connection-classifier=both-addresses:2/0 protocol=tcp
add action=mark-connection chain=prerouting disabled=no dst-address-type=!local dst-port=!80 in-interface=Local new-connection-mark=wan2_conn passthrough=yes per-connection-classifier=both-addresses:2/1 protocol=tcp
add action=mark-routing chain=prerouting connection-mark=wan1_conn disabled=no in-interface=Local new-routing-mark=to_wan1 passthrough=yes
add action=mark-routing chain=prerouting connection-mark=wan2_conn disabled=no in-interface=Local new-routing-mark=to_wan2 passthrough=yes
add action=mark-routing chain=output connection-mark=wan1_conn disabled=no new-routing-mark=to_wan1 passthrough=yes
add action=mark-routing chain=output connection-mark=wan2_conn disabled=no new-routing-mark=to_wan2 passthrough=yes

/ip dns
set allow-remote-requests=yes cache-max-ttl=1w cache-size=5000KiB max-udp-packet-size=512 servers=8.8.8.8, 8.8.4.4

/ip proxy
enabled: yes
src-address: 0.0.0.0
port: 3128
parent-proxy: 0.0.0.0
parent-proxy-port: 0
cache-administrator: Dotnet
max-cache-size: unlimited
cache-on-disk: yes
max-client-connections: 1000
max-server-connections: 1000
max-fresh-time: 3d
serialize-connections: no
always-from-cache: no
cache-hit-dscp: 4
cache-drive: primary-slave



Best regards

ya thanks its working loadbalance with webproxy