MikroTik

Hello

I have one Omnitek with multiple SXT , on each SXT i am getting good result like approx 6Mbps but the result is not stable, the variation in traffic i can see some times the download speed reduced and some time comes stable also the latency on PING is fluctuating, so can any one advice the best configuration of the omnitek and SXT

Also my ominitek configuration is AP-Bridge
SXT Configuration is Station WDS

Nishit

Go to Wireless on the Omnitik and click on registration and send us a screen shot. Your Tx/Rx signal should be in the -50s for best results.

-Mac

attached as requested

only one client has a good signal, better than others but not very good. Your clients are to far away and you need a higher gain antenna base. Omnitk is good for 500m in my opinion.

Hello

If i placed multiple Omnitek in short distance cant affect the Penetration ?? will work properly ?? some one suggest me to use the least device in network so i placed little less equipment

Nishit

What wireless protocol are you using?
Are you using encryption?
Please upgrade to the latest RouterOS v5.23 and do a wireless reset-configuration and configure only the settings you need. Then send us the export compact printout from your configuration:
/interface wireless export compact

Hello

Attached the file

Hi

The omnitik is only for short range, absolute 1km max.

I had a similar problem... http://forum.mikrotik.com/viewtopic.php?f=7&t=66387

Hi,

I am not sure about your environment but in my environment i am running Omnitek with 5KM , 3KM , 1KM , 10KM also & all are working but CCQ for 1KM & 10KM ( Client side RB411AH with 25dbi Aentena) almost same not much diffidence


I am not sure but i made some mistake in configuration.

Can any one help me to set this up !!


nishit T

please show me the ccq for the clients

Hi,

I am not sure about your environment but in my environment i am running Omnitek with 5KM , 3KM , 1KM , 10KM also & all are working but CCQ for 1KM & 10KM ( Client side RB411AH with 25dbi Aentena) almost same not much diffidence


I am not sure but i made some mistake in configuration.

Can any one help me to set this up !!


nishit T

what about wlan card & what signal ranges you getting for those diatance..?
r u using nstrame or nv2..?

Hi,

I am using NV2, NSTREAM

Nishit