mikrotik ccr1036 bonding HP procurve 3400 LACP
not working properly balancing
You do not have the required permissions to view the files attached to this post.
Re: mikrotik ccr1036 bonding HP procurve 3400 LACP
and how do you tested it?
Re: mikrotik ccr1036 bonding HP procurve 3400 LACP
and how do you tested it?
You do not have the required permissions to view the files attached to this post.
Re: mikrotik ccr1036 bonding HP procurve 3400 LACP
I have 2 of your glands CCR1036 and they both behave the same way
Re: mikrotik ccr1036 bonding HP procurve 3400 LACP
That screenshot shows that only one link has traffic. But how do you test it? What is the source and destination mac addresses of packets? If it is from the same source or to the same destination then everything will go over one link only
Re: mikrotik ccr1036 bonding HP procurve 3400 LACP
I have raised between the switch RIPThat screenshot shows that only one link has traffic. But how do you test it? What is the source and destination mac addresses of packets? If it is from the same source or to the same destination then everything will go over one link only
You do not have the required permissions to view the files attached to this post.
Re: mikrotik ccr1036 bonding HP procurve 3400 LACP
in the switch there is no functional load-balanser DST-IP SRC-IP which you can use mikrotik balanser?I have raised between the switch RIPThat screenshot shows that only one link has traffic. But how do you test it? What is the source and destination mac addresses of packets? If it is from the same source or to the same destination then everything will go over one link only