MikroTik

I have upgraded my RB800 board to 6.1 OS.
Link distance is 16km. Bandwidth is 60/60Mb with stable data rate locked at 180/180Mbps.CCQ 100/98%.

However,i cannot able to configure custom channel width. Below is error msg. I have understood from MUM presentation that you can bond 30Mhz custom channel width to make it 60Mhz.

Is this possible?
Im getting error message " license does not allow non-standard channel width" I'm using atheros AR92xx card.

Log into your mikrotik account and upgrade the router OS to allow custom widths. It's free.

Where is that?

I've emailed support, got a form to fill out that I never got around to doing.

Is this the next step after filling out the form?

Where is that?

I've emailed support, got a form to fill out that I never got around to doing.

Is this the next step after filling out the form?

Oh yea forgot about the form but yea after that your account gets enabled for the extras.

But be sure you follow your country rules...

Sent from my GT-I8190N

Thanks.

One reason I hadn't filled mine out was I figured I'd have to fill out one for every device.

Nice.