Hi,

I've setup VLAN trunk ports and access ports on an RB1100AHx2. Everything works very well.

My problem is that I require 10 switch ports (9x trunk and 1x access). With the 2x 5port switches in the RB1100AHx2 I cannot get the trunks from one switch to the other without using up two of the physical ports (one on each switch). Is there a way to trunk the VLANs between the switches without using physical ports?

If not, my only option is to use 2x RB1100AHx2 units (4 internal switches) and use physical ports to trunk between all of them.

Ray

Right. Getting old in my slow age.

Bridging the two master ports solves the problem.

Thanks for the bandwidth.

Ray