Page 1 of 1
Removing Port
Posted: Mon Aug 19, 2013 3:04 pm
by jaykay2342
Hi,
i recently added a usb2serial converter to my LAB device. serial0 appeared and worked as expected. i disconnected the converter but once i try to remove the Port i got
"Couldn't remove Port <serial0> - cannot remove port configuration, port is active (6)"
it's not used by any service at the moment. have someone an idea why this happen and how i can remove it?
Re: Removing Port
Posted: Mon Aug 19, 2013 4:06 pm
by janisk
check if you by change have console attached to that port. '/system console print'
disable if you have an entry for that port and then try to remove it.
or reboot the router.
Re: Removing Port
Posted: Mon Aug 19, 2013 4:09 pm
by jaykay2342
Checked:
- no console
no ups
no special login
already rebooted didn't help
Re: Removing Port
Posted: Fri Feb 14, 2020 12:08 am
by XioneG
Hello
pleace reaply problem..
RouterOS 6.46.3 (Stable)
ailure: cannot remove port configuration, port is active
[admin@MikroTik] /port> remove
numbers: serial1
failure: cannot remove port configuration, port is active
[admin@MikroTik] /port> remove
numbers: serial0
failure: cannot remove port configuration, port is active
[admin@MikroTik] /port> print
Flags: I - inactive
# DEVICE NAME CHANNELS USED-BY BAUD-RATE
0 serial0 1 115200
1 serial1 1 115200
[admin@MikroTik] /port> /port print detail
Flags: I - inactive
0 name="serial0" used-by="" device="" channels=1 baud-rate=115200 data-bits=8
parity=none stop-bits=1 flow-control=none
1 name="serial1" used-by="" device="" channels=1 baud-rate=115200 data-bits=8
parity=none stop-bits=1 flow-control=none
reset configuration device RB 4011
Pleace help support team.
Re: Removing Port
Posted: Sun Aug 23, 2020 2:31 am
by JonathanYoung2161
Same issues