I had a strange issue I would like to share with you. Well, I have a PTP link with RB435G and Compex Atheros AR9220 MINI PCIs. both nodes have a basic configuration as Bridge1 between Ether1 and Wlan1. Bridge IP is 192.168.1.1/24 in the first node and 192.168.1.2/24 in the second node. Wlan1 in the first node is in AP Bridge mode and uses NV2. Wlan1 in the second node is Station Bridge and uses NV2. That is all the configuration and everything was working fine for over 3 months. The issue is that after a blackout, the first node configuration got damaged. I found Wlan1 in the first node disabled and all its configuration changed as the operation mode to station, frequency, protocol, channel, SSID; also, Bridge1 did not have IP address, etc. So I would like to know if you have experienced a similar issue and know if it could happen again or you think is a firmware bug. Thanks
