Page 1 of 1
Getting ERROR:Lost connection when applying changes
Posted: Thu Sep 05, 2013 3:46 am
by loneferret
Hello there,
Well just got RB250GS with SwOS on it. Not bad, although something odd is happening whenever I apply any changes (as in clicking Apply anywhere.)
ERROR:Lost connection is constantly displayed. Funny thing is, I don't actually loss connection.
I've just upgraded to 1.9 since my device came with 1.8 installed. Figured such a small and annoying bug would be fixed.
Only a few hosts in MAC table. Up-time is under 20 minutes.
Am I the only one with this little issue?
Searched the forum, but nothing seemed to correspond with my little problem.
Re: Getting ERROR:Lost connection when applying changes
Posted: Sun Sep 08, 2013 3:46 pm
by loneferret
Guess I'm the only one that has this annoying problem then.
Great...
Re: Getting ERROR:Lost connection when applying changes
Posted: Mon Sep 09, 2013 11:56 am
by rcmcronny
Hi,
in earlier firmwares, this may have been the case, i think it was never really fixed only "workarounded" by setting timeout higher.
I suggest, you contact the mikrotik guys through email directly and if you get something good back, please do not forget to post here also that ,)
Ronny
Re: Getting ERROR:Lost connection when applying changes
Posted: Mon Sep 09, 2013 2:07 pm
by loneferret
I suppose I can try either downgrading/upgrading back to 1.9.
Re-installing SwitchOS...
Will contact support after I've done so... Thanks for the tip.
I just ordered a router from MikroTik, hope this kind of luck doesn't continue.
(Oh and the 'no link' tick doesn't do much. Port is still very much active)
Re: Getting ERROR:Lost connection when applying changes
Posted: Mon Sep 09, 2013 3:40 pm
by rcmcronny
I suppose I can try either downgrading/upgrading back to 1.9.
Re-installing SwitchOS...
Will contact support after I've done so... Thanks for the tip.
I hope you get a good and helpful response.
I suppose I can try either downgrading/upgrading back to 1.9.
I just ordered a router from MikroTik, hope this kind of luck doesn't continue.
Normally, ROS. It has bugs as any other software has to, but you should not have that bad luck again, i think
I suppose I can try either downgrading/upgrading back to 1.9.
(Oh and the 'no link' tick doesn't do much. Port is still very much active)
That is known i think, i have this on my summary thread listed already
Re: Getting ERROR:Lost connection when applying changes
Posted: Tue Sep 10, 2013 7:57 pm
by loneferret
I'll get to it once I get a replacement for my newly delivered and broken router...
Re: Getting ERROR:Lost connection when applying changes
Posted: Wed Jan 29, 2014 6:52 am
by anglenasalt
This may have been the case, i think it was never really fixed only "workarounded" by setting timeout higher.