I have 6 pppoe connections and I was able to configure all of them in RB2011il. The main goal is to combine some Pppoe connection and distribute it to multiple lans (4 LANS).
pppoe1 = 100mbps
pppoe2 = 100mbps
pppoe3 = 40mbps
pppoe4 = 40mbps
pppoe5 = 40mbps
pppoe6 = 40mbps


pppoe1 + pppoe 2 = 200mbps should go to Lan 1
PPPoe3 + pppoe 4 = 80 mbps should go to Lan 2
pppoe 5 = 40 mbps should go to Lan 3
pppoe 6 = 40 mbps should go to Lan 4


note: I am not using a separate modem, I am using MT builtin pppoe client


my problems are:
1. I have internet connection, my Lan is not going to the right direction, eg. LAN 3 is not connectiong to pppoe 5
2. PCC load balancing, i have read this article (http://aacable.wordpress.com/2011/06/04 ... t-by-zaib/) but this shows 4 separate modems are connected to the MT router. I want to exclude the modems and use the builtin pppoe instead.

Any help would be appreciated. Thanks.

anyone?

You can make use of PCC. Just spread the connections over the six connections filtered by in-interface.