If anyone could help please…

I have a 751U which is connected through port 5 (10.47.156.4/27) on a 493G port 5 (10.47.156.1/27).

On port 3 of the 751U there is a 250GS switch connected (10.32.57.134), on the 1st port of the switch there is a Groove connected with (10.32.57.125).

What I am looking to do is to be able to see from a PC (10.47.156.39) which is wirelessly connected on the 493G on an interface with 10.47.156.33/28.

The first port of the 751 is 10.32.57.126/30 the 2nd 10.32.57.1/27 and the 3rd also 10.32.57.1/27 (slave on 2)

I know that I have to give a “temporary” static route on 493 and on the Groove respectively, but am unsure how to do that. Through I.P./Routes and what addresses should I enter?

Thanks in advance

If anyone could help please…

I have a 751U which is connected through port 5 (10.47.156.4/27) on a 493G port 5 (10.47.156.1/27).

On port 3 of the 751U there is a 250GS switch connected (10.32.57.134), on the 1st port of the switch there is a Groove connected with (10.32.57.125).

What I am looking to do is to be able to see from a PC (10.47.156.39) which is wirelessly connected on the 493G on an interface with 10.47.156.33/28.

The first port of the 751 is 10.32.57.126/30 the 2nd 10.32.57.1/27 and the 3rd also 10.32.57.1/27 (slave on 2)

I know that I have to give a “temporary” static route on 493 and on the Groove respectively, but am unsure how to do that. Through I.P./Routes and what addresses should I enter?

Thanks in advance

Uh.... I'm not entirely sure how this thing is setup. Can you post a diagram and your exports?...