MikroTik

Hello.
I have a problem with RB800. I'm not able to get connection through it.
My setting is like SOHO router:

eth1 is WAN (from ISP).
I have DHCP client on eth1 (ip is from 192.168.1.1/24 now)
I setted eth1 as gate (0.0.0.0/0) in IP routes
I have masquerade in NAT (srcnat, out interface eth1)
DHCP obtein looks that works fine

eth2,eth3,wifi are connected to bridge
in IP addresses I have 192.168.2.1/24 on this bridge
I have pool 192.168.2.10-192.168.2.100 and DHCP server on this bridge.

wifi is setted as AP bridge, 2x2 2,4GHz 802.11n, WPA2 security

ROS v6.7

Now the problems:
1.) when I connect some PC to RB (wifi or eth, doesn't care), I get IP right, but netmask is wrong (I get 255.0.0.0 instead of 255.255.255.0)
2.) I'm not able to get connection through the RB. I can connect to RB, but that's all. But from RB (via winbox) I can reach internet without problem.

It's probably some missed settings, but I'm still not able to find it

Thanks for any help!

Look under DHCP server and make sure that you have an appropriate "Network" configuration for 192.168.1.0/24. The gateway for the DHCP clients is also set in there.

Thanks!
I found that it didn't gave me also gateway. After adding to DHCP-networks it works OK

@ Benik3

I would like to know how you setup your config. for the Second LAN for WiFi.

I just posted a note in forum about implementing a Second LAN for office machines on my RB951G

Would you mind posting your config or reply to my forum question.
You may omit your information from the config if you like.

Thanks!

What you mean with Second LAN?
Off course I can post for you my config