Page 1 of 1
Is it possible no one can help me?
Posted: Fri Mar 21, 2014 6:59 pm
by samir
Is it possible no one can help me for my problem i Tried everything but its same ccq is not good but signal is good
see this pic
Re: Is it possible no one can help me?
Posted: Fri Mar 21, 2014 8:45 pm
by zyzelis
Is it possible no one can help me for my problem i Tried everything but its same ccq is not good but signal is good
see this pic
I hope it will help you... signal is good
Re: Is it possible no one can help me?
Posted: Fri Mar 21, 2014 10:19 pm
by plisken
Try to reduce the output power.
Re: Is it possible no one can help me?
Posted: Sat Mar 22, 2014 1:30 pm
by samir
Try to reduce the output power.
i tray but its same ?
Re: Is it possible no one can help me?
Posted: Sat Mar 22, 2014 1:33 pm
by plisken
Try another channel.
Re: Is it possible no one can help me?
Posted: Sat Mar 22, 2014 2:52 pm
by samir
Try another channel.
i tray but its same how moch i can make output power and u can Help me through the program TeamViewe pls
Re: Is it possible no one can help me?
Posted: Sat Mar 22, 2014 3:50 pm
by CyberTod
Do you have more than 1 antenna very close to each other ?
Re: Is it possible no one can help me?
Posted: Sat Mar 22, 2014 4:53 pm
by samir
Do you have more than 1 antenna very close to each other ?
I have many of them on the tower I think that's the direction of the tower where many Noise How can I get rid of Noise
i have 3 Customer have this problem the other dont have and just in p2p
Re: Is it possible no one can help me?
Posted: Sun Mar 23, 2014 2:25 am
by joshaven
The rx CCQ being so low means that much of the information your radio is receiving is not usable. I would suspect an antenna issue or some reflection issues. Do you have something large near by that the signal could be reflecting off of? I don't think its interference because your signal to noise level is good.
Joshaven Potter
http://joshaven.com
Sent from my iPhone using Tapatalk
Re: Is it possible no one can help me?
Posted: Sun Mar 23, 2014 2:28 am
by joshaven
It also seems odd that your only showing two modulations do you have most of the others disabled? I would go back to the default modulations if you have them customized.
Joshaven Potter
http://joshaven.com
Sent from my iPhone using Tapatalk
Re: Is it possible no one can help me?
Posted: Sun Mar 23, 2014 12:16 pm
by samir
It also seems odd that your only showing two modulations do you have most of the others disabled? I would go back to the default modulations if you have them customized.
Joshaven Potter
http://joshaven.com
Sent from my iPhone using Tapatalk
hi
if u have mail i can show u all i tray evry think but its same its just in Mikrotik RB912 i have ubnt roket no problem with this
Re: Is it possible no one can help me?
Posted: Sun Mar 23, 2014 9:18 pm
by CyberTod
These problems with low ccq are always from cable, antenna or interference. Don't blame the board or settings. But if you fixed the bitrate try going auto for test.