MikroTik

Posted: **Thu May 15, 2014 4:49 pm**

Hello everyone, i need your assistance in assigning public ip address to a client on my LAN.
We are an ISP, we are running a bridge network and i am using mikrotikOS as my gateway. I have a client that want to be able to access his DVR to view his cameras from anywhere outside my network and I have a spare public ip address that i want to use for him.
I need someone to tell me on how to set him up on my (MIKROTIK) gateway.
Looking forward to quick response.

regards to you all

Posted: **Thu May 15, 2014 8:19 pm**

Do not give the address to the client, or your network will be flooded by all the junk traveling on the net,
instead make NAT rules for the camera...

Posted: **Fri May 16, 2014 12:38 am**

Do not give the address to the client, or your network will be flooded by all the junk traveling on the net,
instead make NAT rules for the camera...

please i would like you to help me with the command to do it.
Thanks

Posted: **Fri May 16, 2014 12:51 am**

You usually do that by making one-TO-one NAT on your gateway. If you really want some node to have public IP you need to route it to next hop.

MikroTik

How do i make device on a LAN wit public ip to get to net

How do i make device on a LAN wit public ip to get to net

Re: How do i make device on a LAN wit public ip to get to ne

Re: How do i make device on a LAN wit public ip to get to ne

Re: How do i make device on a LAN wit public ip to get to ne