MikroTik

Posted: **Sun Jul 06, 2014 2:56 pm**

Hello, i can't monitor voltage and current in my RB951. When i issue this commands as you told in another post i get this:

 /interface ethernet poe settings print
bad command name settings (line 1 column 25

With

interface ethernet poe monitor ether5

i get only this message:

name: ether5
poe-out-status: powered-on

Poe setting version prints 0.0 in winbox.

Would you be so kind to help me to find the problem? I think more people has the same problem than me.

Thank you very much.

Posted: **Mon Jul 07, 2014 7:54 pm**

RB951Ui-2HnD like all RB2011i series do not have any monitor or settings on "i" port (except PoE auto on / forced on / off).

This is not the 750UP or OmniTIK UPA-5HnD, the "i" board have only 500mV support @ 24V, just for power one SXT or Sextant.

Posted: **Thu Jul 10, 2014 8:37 pm**

Ah, thank you very much!

I didn't know that, i've read the wiki but maybe i didn't see it.

Thanks again!!!

MikroTik

RB951Ui-2HnD v6.15 no poe settings available

RB951Ui-2HnD v6.15 no poe settings available

Re: RB951Ui-2HnD v6.15 no poe settings available

Re: RB951Ui-2HnD v6.15 no poe settings available