Page 1 of 1

Ethernet interface Up\Down

Posted: Fri Jul 18, 2014 11:07 am
by nosovk
I saw that all ethernet interfaces on one of mikrotiks are going down, and getting up after one second.
I use ROS 6.15 on RB751G-2HnD. I've attached log screen.
Somebody have any ideas what can cause such a problem?
It worked ok week before, it begun just today :(

Re: Ethernet interface Up\Down

Posted: Fri Jul 18, 2014 11:34 am
by kameelperdza
Hi there.

Had the same problem.

You should test cable with cable tester.
One of the wires might be broken.
OR you can replace the cable with new one instead.
Should fix the issue

--EDIT--

Might also be interference?

Re: Ethernet interface Up\Down

Posted: Fri Jul 18, 2014 11:38 am
by nosovk
i've already tested 3 of 5. All seems to be ok.
I try to downgrade to 6.14. Seems to be ok now :)

Re: Ethernet interface Up\Down

Posted: Fri Jul 18, 2014 12:55 pm
by nosovk
I was wrong.
Downgrade didn't help and all cables are ok :(

Re: Ethernet interface Up\Down

Posted: Fri Jul 18, 2014 1:15 pm
by kameelperdza
you can also try to downgrade/upgrade firmware.

/system routerboard upgrade


btw I also thought my problem was solved. But ether1 still does it at random times.

Re: Ethernet interface Up\Down

Posted: Sat Jul 19, 2014 9:34 am
by nosovk
I've opened support ticket with that question. Lets wait for official answer :)

Re: Ethernet interface Up\Down

Posted: Sat Jul 19, 2014 9:38 am
by docmarius
Another cause of this is can be RFI.
Seen it with a radio transmitter with some increased SWR having its antenna cable near the ethernet cable.
Link did go down on radio Tx. And it was just a puny 4W CB radio. Tuning the antenna sorted all out.

Just to keep that in mind...

Re: Ethernet interface Up\Down

Posted: Sat Jul 19, 2014 11:21 am
by Petzl
do you use FTP cable ?

Re: Ethernet interface Up\Down

Posted: Sat Jul 19, 2014 11:36 am
by nosovk
I use UTP indoors, and FTP in outdoors connections. This router is more switch than rouer - it have 5 UTP links to another mikrotiks, who works like ap's.

Re: Ethernet interface Up\Down

Posted: Sat Jul 19, 2014 2:23 pm
by reinerotto
A typical reason is "Auto negotiate ON". I even had the case, that the Ethernet-link between two NT-routers of same type went up and down, because they could not always agree upon the link speed to be used.
So you might try to set both sides of the links affected to 100MBit, half dplx. And see, what happens.

Re: Ethernet interface Up\Down

Posted: Wed Feb 14, 2018 2:07 pm
by andy76sz
Thank you reinerotto. Thanks to you I solved the problem with the printer losing printouts after leaving the standby mode.
Andy