MikroTik

Hello,

I have a network with a Bridge for a LAN and also I have 2 ISP conections on this router to Internet. I want to do manuall load balancing with different IP pool. The internet traffic work OK, but the problem is that if I enable the routing mark I can't acces from the same LAN to one IP in ISP1 to a IP in a ISP2.

0 ;;; ROUTING MARK
chain=prerouting action=mark-routing new-routing-mark=400MB
passthrough=no src-address-list=IP_400MB


0 A S dst-address=0.0.0.0/0 gateway=62.x.x.x
gateway-status=62.x.x.x reachable via vlan911 distance=1
scope=30 target-scope=10 routing-mark=400MB


Thanks

Do you mean that you cannot conenct to public ip on isp2 or do you mean the ipaddress of the router on isp2?

hello

I mean that I can't reach the net that I have on routing. mark from non routing mark net that is on the same bridge

Have you change you natting rules?

Under ip firewall nat change the srcnat masquerade rule and add routing mark to it.
That should work.
I have done this a very long time ago, not sure if you shoudl chose routing table or routing mark under srcnat rule.