SXT ac - Current TX Power display don't work ?
Posted: Thu Aug 14, 2014 10:15 am
On SXT ac (ROS 6.18) current TX power display value is all the time 0dBm. Is this due chip change (Atheros->Qualcomm) or different problem?
MikroTik
Community discussions
https://forum.mikrotik.com/
SXT ac - Current TX Power display don't work ?
Page 1 of 1
Re: SXT ac - Current TX Power display don't work ?
Posted: Thu Aug 14, 2014 1:17 pm
you must activate first the wlan
Re: SXT ac - Current TX Power display don't work ?
Posted: Thu Aug 14, 2014 1:22 pm
I have active link with only AC, but txpower is always 0.
Re: SXT ac - Current TX Power display don't work ?
Posted: Thu Aug 14, 2014 1:55 pm
Sent a supout.rif last week. Should be a known bug.I have active link with only AC, but txpower is always 0.
Re: SXT ac - Current TX Power display don't work ?
Posted: Sun Sep 07, 2014 1:15 pm
I see the same here.
Also the signal on a 3,5 km link is very bad. So I asume that really no tx power is being used.
I have tried all settings that I found. No change.
Also the signal on a 3,5 km link is very bad. So I asume that really no tx power is being used.
I have tried all settings that I found. No change.
Re: SXT ac - Current TX Power display don't work ?
Posted: Mon Jan 18, 2016 11:18 am
any udate about that? RB911G-5HPacD and RB922UAGS-5HPacD the same problem with current tx power...
Re: SXT ac - Current TX Power display don't work ?
Posted: Mon Jan 18, 2016 12:16 pm
I think it's related to all "ac" chipsets. I have miniPCI cards R11e-5HacD with same situation, there is nothing in the "Current Tx Power" tab.
Re: SXT ac - Current TX Power display don't work ?
Posted: Thu Mar 31, 2016 5:40 pm
This is still happening with RB911G-5HPacD and RB922UAGS-5HPacD under ROS 6.34.4 w/ firmware 3.31.
Posted: Thu Mar 31, 2016 11:06 pm
Same situation with RouterBOARD 952Ui-5ac2nD
Sent from my Lenovo K50a40 using Tapatalk
Sent from my Lenovo K50a40 using Tapatalk