Page 1 of 1
UPNP Status command
Posted: Tue Nov 18, 2014 8:58 pm
by ryandenis
Is there a CLI command to view the status of UPNP mappings or the status in general, or is there something available in the web gui?
Re: UPNP Status command
Posted: Wed Nov 19, 2014 1:45 pm
by plisken
Is that what you main?
[jp@CRS-JP] /ip upnp> print
enabled: no
allow-disable-external-interface: no
show-dummy-rule: yes
[jp@CRS-JP] /ip upnp>
Re: UPNP Status command
Posted: Wed Nov 19, 2014 1:50 pm
by CyberTod
You can view all added mappings in IP -> Firewall -> Nat
They are added as dynamic rules. But what is missing and I want to see added is the name of the program that made the mapping, because this info is given by the programs and other routers are showing it. Maybe as a comment on the rules or in some other way.
Re: UPNP Status command
Posted: Wed Nov 19, 2014 5:23 pm
by ryandenis
So its safe to assume if there's nothing in the gui but the NAT rules I've added its not adding anything automatically yet... Thats what I was afraid of, I don't even know if I have it configured properly or not but with the amount of Apple devices and media devices inside this network there should be tons of upnp rules popping up.
Re: UPNP Status command
Posted: Wed Nov 19, 2014 6:13 pm
by CyberTod
If you have configured it correctly it is adding rules. I have lots of them on some routers. They don't even have some sort of timeout, just stay there until reboot it seems.