MikroTik

A few months ago I had a CCR1036 configured just fine with BGP with a public AS getting a full route table in a lab. I let it sit up until recently and now it appears like any outbound pings from the CCR experience roughly 50% loss. It'll be successful for one minute, then completely time out the next. Pinging *to* the CCR's public IP is always successful.

I'm using one Peer and no custom routes. I've tried firmware versions 6.20, 6.19, and 6.04. All yield the same results. Any ideas?

I figured this one out. After taking a look at the route filters in place, I noticed our (now offline) Edge 2 was in "Set In Nexthop" for the inbound BGP filters along with our Edge 1 router. After taking Edge 2 out, everything works great.