in the CRS 226, how can i block netbios in switch mode??
Posted: Wed Feb 11, 2015 4:01 pm
Hello.
i want Netbios(TCP 137 / 139) Block in CRS226 all Port
(Switch Mode - ether1 is none set,and All other ports is set ether1 Master) ..
But, i can not find any CRS Series Switch ACL Rule Examples in MikroTik Wiki..
it is too hard..and Error (matchers can be used only for ip or ipv6 mac-protocol(6)
Does anyone have an ACL example?
Thanks.
i want Netbios(TCP 137 / 139) Block in CRS226 all Port
(Switch Mode - ether1 is none set,and All other ports is set ether1 Master) ..
But, i can not find any CRS Series Switch ACL Rule Examples in MikroTik Wiki..
it is too hard..and Error (matchers can be used only for ip or ipv6 mac-protocol(6)
Does anyone have an ACL example?
Thanks.