MikroTik

Hi All,

I am preparing to move my current router / wifi setup to a RB2011iL-RM & cAP 2n and plan to power the cAP 2n form the PoE port on the router.

I hate plug packs so I was going to install a psu inside the RB2011iL-RM case.

This is a possible candidate

http://www.jaycar.com.au/productView.as ... TID=999#12

I notice the supplied plug pack is 20w.

Anyone done this before and got some photos or suggestions on other psu's the more efficient the better.

Cheers

Chris

Maybe look at the 24v power supply
http://www.jaycar.com.au/productView.as ... TID=999#12
With POE to the AP the higher voltage will help.