RB2011 is in transit (this unit has wifi on board)


I am hoping to obtain the following configuration on this new solution

2 Vlans or network segments to achieve:

Vlan -1 with DHCP 192.168.10.5/15 routed to the internet

Vlan -2 (Xenserver host Vlan) - no DHCP scope but address space is 192.168.1.5/100 DHCP, PXE and TFT are contained within this group but the broadcast of DHCP scopes needs to be limited to exclude the office dhcp scope or VDI's looking for scopes will fail on reboot. I know this must be achievable as its basic Vlan and DHCP setup -

Wireless - one SSID broadcast for the network range 192.168.10.x with inter vlan routing to 192.168.1.x so that I can use any laptop in the LAN as a management interface for Xenserver or ESX -



Firewall - I need the following ports open to the internet

1494 - internal destination address 192.168.1.170/8/26
3389 internal destination address 192.168.1.170/8/26
2598 internal destination address 192.168.1.170/8/26
2512 internal destination address 192.168.1.170/8/26

Can I do this on the Firewall of this device? Or will I need to use a VPN into my lan ?

If this can be done is there deployment script that is close I could look at from the user community ? I understand you can do everything via CLI on this device.