Hi all in here.
I rely need some help to setup cap 2n with primary ap and 2 virtual ap there are running with VLAN 100, 200 and 300.
My switch is cisco and port to cap from cisco is trunk with VLAN 100,200,300 and VLAN 999 for no use.
My setup on cap is:

/interface vlan
add name=vlan1-ether1 interface=ether1 vlan-id=100
add name=vlan2-ether1 interface=ether1 vlan-id=200
add name=vlan3-ether1 interface=ether1 vlan-id=300
add name=vlan999-ether1 interface=ether1 vlan-id=999
/interface bridge
add name=bridge-vlan100
add name=bridge-vlan200
add name=bridge-vlan300
/interface bridge port
add bridge=bridge-vlan100 interface=vlan100-ether1
add bridge=bridge-vlan100 interface=vlan100-Wlan1

add bridge=bridge-vlan200 interface=vlan200-ether1
add bridge=bridge-vlan200 interface=vlan200-wlan2 (virtual AP)
add bridge=bridge-vlan300 interface=vlan300-wlan3 (virtual AP)

I cant get it to work, and I am not sure this is the right way ?
I also try:

/interface vlan
add name=vlan1-ether1 interface=ether1 vlan-id=100
add name=vlan2-ether1 interface=ether1 vlan-id=200
add name=vlan3-ether1 interface=ether1 vlan-id=300
add name=vlan999-ether1 interface=ether1 vlan-id=999
/interface bridge
add name=bridge-vlan100
add name=bridge-vlan200
add name=bridge-vlan300
/interface bridge port
add bridge=bridge-vlan100 interface=vlan100-Wlan1
add bridge=bridge-vlan200 interface=vlan200-wlan2 (virtual AP)
add bridge=bridge-vlan300 interface=vlan300-wlan3 (virtual AP)
But something is worng cus the net is going down?
I also don’t know where to put the ip? My ges wil be on bridge-vlan100 bur not sure?
The cap running with router off.
I rely hope somone can help out here?

Cheers
Jimmy